Medical equipment
Hydraulic Operating Table DST-IC
Operating table without any electrics, the height set by a foot-operated oil pump. It runs on castors, measures at least 2000 x 500 mm and comes with a broad set of accessories.
The adjustment is purely mechanical, so a power cut in the building leaves the table untouched. Pumping is done by foot. The top can be raised by at least 300 mm and its lowest position is 670 mm.
It is intended for thoracic, ENT, gynaecological, urological and orthopaedic procedures. Anaesthesia screen, shoulder holders, arm boards, support frames, leg supports and mattress are part of the delivery. The oil can and the crank for the kidney bridge are included as well.
Technical data
- Table length and width
- ≥ 2000 mm / ≥ 500 mm
- Minimum table height
- ≤ 670 mm
- Table top travel
- ≥ 300 mm
- Tilt backward and forward
- ≥ 30° / ≥ 25°
- Lateral tilt left and right
- ≥ 20° / ≥ 20°
- Head section up and down
- ≥ 60° / ≥ 75°
- Leg section folding
- ≥ 15° / ≥ 90° / ≥ 90°
- Back section folding
- ≥ 70° / ≥ 30°
- Kidney bridge lift
- ≥ 120 mm
- Accessory anaesthesia screen
- 1 piece
- Accessory shoulder holder
- 2 pieces
- Accessory arm board
- 2 pieces
- Accessory support frame
- 2 pieces
- Accessory leg support
- 2 pieces
- Accessory mattress
- 1 set
- Accessory long slider
- 2 pieces
- Accessory slider
- 7 pieces
- Accessory foot board
- 2 pieces
- Accessory oil can (filled)
- 1 piece
- Accessory crank for the kidney bridge
- 1 piece