No image yet
Photovoltaics
Flat Roof Mounting System MRac RM-Ad
Ballasted racking for flat concrete roofs, membrane roofs or level ground. Concrete ballast holds the array, the tilt angle runs from 0 to 30 degrees, and the design covers wind up to 44 m/s.
The array is set up symmetrically in two directions. Concrete ballast provides the hold-down, and the load-bearing parts are hot-dip galvanised Q235B steel and anodised AL6005-T5.
Framed and frameless modules of any width can be laid out in landscape. For the fasteners the table names SUS304 stainless steel, hot-dip galvanised steel and zinc-nickel electroplated steel; the snow load is stated as up to 1.6 kN/m².
Technical data
- System name
- MRac Roof Solar PV Mounting System RM-Ad
- Installation site
- Flat concrete roof, flat ground, membrane roof
- Ballast
- Concrete ballast
- Tilt angle
- 0-30°
- Wind load
- ≤44 m/s
- Snow load
- ≤1,6 kN/m²
- Suitable modules
- Framed or frameless, any panel width
- Module orientation
- Landscape
- Design codes
- Eurocode EN 1991/1993/1994, BS 6399, ASCE 7-10, IBC 2009, CBC 2010
- Material
- Q235B hot-dip galvanised; AL6005-T5 anodised
- Fasteners
- SUS304, hot-dip galvanised steel, zinc-nickel electroplated steel
- Small parts
- AL6005-T5, anodised
- Colour
- Silver or customised
- Warranty per factory table
- 10 years